Watco 48600-CP Bedienerhandbuch PDF herunterladen

uick

rim

™

Kits

INSTALLATION INSTRUCTIONS

Stretch an o-ring into the groove on the

shaft of the

uick

rim

™

Press the

uick

rim

™

into the strainer

body. Install stopper assembly.

If it drops in loosely, remove the skinny o-ring and replace it

with the fat o-ring. It should t tightly when pressing it down

into the strainer body. If the t is too tight, wet the o-ring and

then press it into the strainer body.

Lift

and Turn, PUSH PULL

, and Foot Actuated replacement

stoppers are available.

Let Watco’s Trim Kits and Tub Closures

make your bath waste problems fade away!

NuFit

TRIM KIT & TUB CLOSURE INSTALLATION INSTRUCTIONS

1. Remove all oils, dirt, and cleansers from the

strainer body.

2. Aim the adhesive on the shaft.

3. Use all of the adhesive in the tube.

4. Press the NuFit

onto the old strainer body.

5. Remove excess adhesive.

6. Let dry for 24 hours before use.

NuFit® stoppers available:

NuFit

Lift and Turn .....Requires minimum 1.390” I.D. opening; ange covers maximum of 2.875” O.D.; depth clearance needed = .390”

NuFit

PRESFLO

.......Requires minimum 1.490” I.D. opening; ange covers maximum of 2.875” O.D.; depth clearance needed = .850”

NuFit

PUSH PULL

... Requires minimum 1.410” I.D. opening; ange covers maximum of 2.875” O.D.; depth clearance needed = .860”

WATCO has

repair or replacements parts

available for brass drains!

TO CONVERT EXISTING 1-HOLE AND 2-HOLE OVERFLOW PLATES

TO THE SNAP-ON INNOVATOR® OVERFLOW PLATE

Remove screw from existing

overow plate. Save screw to

use to attach adapter bar.

With the screw from the original faceplate screwed into the

hole in the adapter bar, secure the adapter bar and retainer

ring to overow elbow.

Snap the Innovator

overflow plate onto the

retainer ring, making sure the opening on the

overow plate is facing down towards the tub.

For 2-hole overow plate: Use same procedures above except use both original screws to secure the adapter bar to the OE.

Patented; Patent Pending

For use with watco

coarse-thread strainer bodies

Patented; Patent Pending

Please contact:

Assembed on OF on tub.

Behind tub. Inside tub.

WATCO has 1

Inhaltsverzeichnis

Seite 1 - WATCO has

QuickTrim™ Kits INSTALLATION INSTRUCTIONSStretch an o-ring into the groove on the shaft of theQuickTrim™.Press theQuickTrim™into the strainer body. I

Kommentare zu diesen Handbüchern

Keine Kommentare

Watco 48600-CP Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Kabelschnittstelle / Gender-Adapter Watco 48600-CP herunter. Watco 48600-CP Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern